How To Change Your Disarm Code

The owner authorization code is used for authorization by means of the standard car buttons. Do as follows to change the owner authorization code:

Written Instructions

  1. Disarm the system using the existing code or tag/smartphone

  2. Switch on the ignition.

  3. Press any button on the Starline network 5 times.

  4. Switch ignition off and on.

  5. 5x sound signals will follow, confirming entry in the code change mode.

  6. Enter the owner authorization code using the standard buttons.

  7. In 3 seconds after the end of owner code entry, 2 short signals of the sound alarm will follow.

  8. Enter the owner authorization code again.

  9. If the code matches, 2 short sound signals will follow. Otherwise, a long sound signal will be heard, repeat items 6...8.

  10. Switch off ignition

  11. After 1 minute... test the new code

Video Instructions

Notes : 

  1. pressing interval not more than 3 seconds. Hold the button until a confirming sound signal is heard)

  2. The new owner authorization code can consists of a code sequence, containing 3 to 10 pressings of the standard buttons.

 

Forgotten The Code

If you have forgotten to disarm sequence or it is not working for whatever reason you can use the emergency code on the red card that came with your i96. The number you are looking for is the 4 digit number under the scratch off area.

 

To use this you need to follow the steps provided in the Emergency code help section

Written Instructions

  1. Switch on the ignition.

  2. Press any button on the Starline network the number of times corresponding to the first digit of the code of emergency security deactivation.

  3. Switch off the ignition. A signal confirming the digit entry will follow.

  4. Repeat items 1...3 for the remaining digits.

  5. If 3 short signals will follow, the code of emergency security deactivation was entered correctly, 1 long signal — the code was entered incorrectly.

Video Instructions

Notes : 

  1. If the code of emergency security deactivation is entered incorrectly 5 times, the possibility of repeated code entry will be blocked for 15 minutes.

 

How To Enter & Exit Valet Mode

Service / valet mode allows you to hand over the keys to your car to someone without having to give them your disarm sequence. This way they get to know that your car is protected by the Ghost. Use this mode when you take your car for service or valet parking. Here are a few key points about service mode.

  1. Allows for an indefinite amount for starts and drives without needing the disarm sequence

  2. Turns off all key learning protection (this is still active when the Ghost is disarmed!)

  3. Can be manually turned exited

  4. Will exit automatically when driven for a reasonable time

  5. The disarm sequence can be between 4 and 20 presses of any of the working buttons and buttons can be repeated

  6. The service/valet button however can only be used 4 times in the disarm sequence

  7. Decide what you want your new sequence to be before starting this procedure!

Written Instructions

​Enter Valet Mode

  1. Disarm the system using the existing code or tag/smartphone

  2. Switch on the ignition.

  3. Press any button on the Starline network 11 times.

  4. Switch ignition off and on.

  5. 2x sound signals will follow, confirming entry into Valet Mode

​Exit Valet Mode

  1. Ignition On

  2. Enter your normal disarm sequence

  3. 2x sound signals will follow, confirming exit of Valet Mode

Video Instructions